Site map
Bench Top Programming Harness
Here you will find Bench top programming
harness products to recalibrate or flash your ECM.
LSx, LT1, TPI, TBI, Vortec, OBD one, and OBD two.
If you don't find the harness you need please
E-mail me. kerry@americanhotrodsolutions.com
If you need other pigtail,
connector, or harness products please click this link.
|
|
|
Switch Assembly Main Harness $76.00 You will
need this switch assembly and the proper harness below to program you PCM.
OBDI and OBDII interface cable and software are not included.
This is a good source for cables.
|
|
|
|
LS1 Bench top Programming Harness $95.00
|
|
Vortec Bench top Programming harness $90.00
|
|
1996-97 LT1 harness for OBD2 Cost $100.00
|
|
LT1 94-97 Bench top Programming harness $165.00
For programming you
will need an interface cable.
This is a good source for cables. |
|
|
|
E-40 ECM and TCM Harness $120.00
|
E-mail
Kerry at American Hot Rod Solutions.
Product Guide
American Hot Rod Solutions
home page.
Harness Construction
All Connection harnesses are built with TXL wire. This is the same wire used in the original GM harnesses. TXL wire is resistant to fluids and has a temperature range of -59°F to +257°F.
Delphi Connectors and Terminals
Harnesses are built using Delphi connectors and terminals. These connectors and terminals are exclusively used in the original TPI harnesses. Delphi components are still used in new automotive harnesses today.